Otdr Testing Launch Cable Length

The optical time domain reflectometer otdr is an essential tool.

Otdr testing launch cable length.

Otdr testing with launch cable. Available in 160m 525 length 50 µm or 62 5 µm multimode and 9 µm single mode fiber optic cable options. The length of the launch and receive cables depends on the link being tested generally between 300 m and 500 m for multimode testing and between 1000 m and 2000 m for single mode testing. What is a launch cable used for.

This help to avoid variations in loss and distance measurements when testing. Selecting a 150 m spsb or a 300 m ltc psb would therefore be appropriate. Launch receive cables for automated bi directional fiber optic testing and pass fail analysis of two fibers in a single test using the smartloop otdr. The chosen launch test cable should therefore be longer than the pulse dead zone used for the tests.

It can verify splice loss measure length and find faults. For very long haul 4000 m of cable may be used. The optical time domain reflectometer otdr is useful for testing the integrity of fiber optic cables. Measurement using a launch cable launch cable launch cable otdr 1m patchcord bulkhead reflective event with loss fiber under test start of fut end of fut end of launch cable these reflections will be small if the connectors are clean in good condition clean protect the launch cable connectors 1m patchcord.

The next step in setting up an otdr test is the proper connection of launch and receive cables at either end of the fiber link. The launch cable is the link between the otdr test port and the fiber link being tested it is used to stabilize the test pulse and to enable the otdr to recover from transmitting the test pulse in order to see. The launch fiber cable helps to negate blind spots or the dead zones of an otdr which occures when there is high launch power or faults near the. For instance a 1 µs pulse is approximately 100 m long.