Takes approximately 3 4 hours until full charge.
Owlet sock sensor not charging.
Once the lights have turned off wait 60 seconds and then plug the smart sock electronics back into the base.
Charge the sock battery by plugging the sensor into the base station and the base station into an electrical socket.
Track your baby s heart rate oxygen levels and sleep all while streaming live video.
The owlet smart sock is not a fda approved medical device and is designed and intended for families with healthy infants.
The owlet smart sock is a consumer product that provides parents insights into their baby s wellness as well as peace of mind each time the parent puts their child down for a nap or to sleep at night.
Battery lasts approximately 18 hours this can vary depending on the physiology of your child.
Open the owlet app and check the smart sock battery gauge under settings in the lower left corner.
Monitor what matters most.
With these changes the sock now fits babies both bigger and smaller from 5 lbs.
It also monitors babies through gentle motion so you get live readings more often.
The base station is not accepting a.
If your goal is to turn the electronics off stop here.
The sensor is the white electronic inside the fabric sock and shown in the picture below.
Examples of poor sock fit.
Charge at least every day.
A base station receives the signal from the smart sensor device that gets attached to the socks.
If the lights will not turn off use a refrigerator or similar magnet dragging it across the bottom of the electronics dome.
The sensor charging cable needs to be replaced.
These four reasons are.
Get an 8 hour charge in under 20 minutes and a full 16 hours in 90 minutes.
There are four possible reasons why your sensor is not charging.
Please note that this is not a type c micro usb port.
How to charge the smart sock.
Smart sock fit placement.
On the front there is a logo and on the side are two micro usb port to charge the base station and to charge the sock sensor.
And the redesigned base station offers wireless drop and go charging a huge time saver.
The base station receives information from the owlet s pulse readings.
Reset turn off the smart sock.
Below we will review all four reasons.
Pairing your new sock.
For a simple reset turn the electronics back on.
The owlet app will not display the charge amount while the sock is plugged in and charging.
You may continue to have blue notifications and will not be able to get reads if your smart sock battery is dead or dying.
Sock plugged in sock in use not charging if needed re charge the smart sock.
